ShockRocket™ Head Popper Launch Ready Kit
$598.99
No actors. No reset delays. Just pure, repeatable terror.
Meet the ShockRocket™️ Head Popper Launch Ready Kit, the modular scare engine that powers the next generation of haunt technology. Designed for durability and precision timing, this patented popper mechanism launches startling head effects with lightning-fast reset capability, delivering thousands of scares per night without fatigue, missed cues, or actor burnout.
Built for haunt operators, theater designers, and serious home haunters, the ShockRocket™️ provides a plug-and-play foundation for custom scare builds. Swap payload heads, mount it inside props, or integrate it into scenic elements to create endlessly surprising effects.
This Launch Ready Kit includes:
- A two-output pre-programmed prop controller
- Simple push-button trigger system
- Speaker
Just add compressed air and prepare for liftoff!
Plywood base not included—shown for mounting demonstration purposes only.
| Dimensions | 11 × 11 × 27 in |
|---|---|
| Air Connection | Male Quick Connect Style Air Input, 1/2 Inch Push-To-Fit Air Input |
A 288-piece mechanics tool set is mandatory...just kidding. A #2 phillips screw driver, plumb bob, and torpedo level. Sometimes a pair of needle nose pillars will help thread the guide lines through the winches.
12v DC 5-amp power supply. When the valve is sharing power with a prop controller, a 5-amp power supply is required. Using a sub 5-amp power supply will cause your prop controller to enter a brown out condition upon trigger and will result in (most likely) your prop controller to reset itself.
Just about any trigger supported by your prop controller can be used. Push buttons, beam breaks, pressure mats, PIR, etc...
No! A simple push button that sends 12v DC to the valve will get it poppin.
Our interchangeable head modules let you change your theme without changing your tech. Each module snaps into place in seconds. Fright variety has never been easier.
Practically instant. The ShockRocket™ is designed for high-traffic haunts—trigger, scare, reset, repeat. No delay. No downtime. Just relentless, automated chaos. While the ShockRocket will be ready to launch again as soon as it lands and the screams stop, the performance of your air compressor is determining how often you can trigger the prop.
Generally 25PSI will give about five (5) feet of travel. 40PSI will be good for about eight (8) feet of screams.Your mileage will vary. Always start with a low (15PSI) pressure and slowly add PSI until reach your desired altitude.
ShockRocket’s need at minimum a ⅜ line, but ideally ½ inch for best performance. In addition to correct lifting PSI, the high flow air valve of the head poppers needs a large volume of air to lift the payload. At least six (6) feet of ⅜ or ½ inch air line between the ShockRocket and your compressor pressure valve is needed to supply enough volume for a launch.
No. Adjust the tool pressure gauge to the correct lifting pressure.
Over 10,000 and counting. We built it to survive a full season of shrieks (and then some) in the most punishing haunt environments.
It’s not afraid of the dark—or a little drizzle—but for best performance, we recommend shelter from direct rain and weather extremes.
Plug it in. Secure it. No programming skills or engineering degree required.
Reviews
There are no reviews yet.